Porcelain tile adhesive and large dimensions | Dexter
Porcelain tile adhesive and large dimensions is a mixture of cementitious materials with polymer additives and adhesive boosters and mineral fillers and is ready to use only by adding water. It is used for installing all kinds of porcelain tiles and large dimensions inside and outside the building, as well as tiles on tiles.
Features of porcelain tile adhesive and large dimensions:
Ability to run on vertical and horizontal surfaces
Superb grip strength
Extreme adhesion to the surface of old tiles
Ease of implementation
Uses of porcelain tile adhesive and large dimensions:
Install tiles on wall and floor tiles
Floor and wall tiling
Installation of porcelain tiles and large dimensions on a variety of surfaces
Installation of porcelain tiles and large dimensions inside the bathroom and toilet
Installation of porcelain tiles and large dimensions inside and outside the building
Consumption of porcelain tile adhesive and large dimensions:
Depending on the surface of the work and the grooves behind the tile, about 2.5 to 4 kg is required to cover one square meter.
Execution tips of porcelain tile adhesive and large dimensions:
The application surface must be firmly clean, dry and free of dust and loose particles. Loose paints and coatings should be removed before applying the adhesive. The surface of gypsum walls (chipboard), lightweight concrete and wall panels should be saturated with primer 3 hours before tiling.
How to use porcelain tile adhesive and large dimensions:
۱. Each 25 kg bag should add 6 to 7 liters of water. Mixing the powder with water should be done using an electric mixer.
۲. Always add the powder slowly to the water and note that when the powder is added to the water, the electric mixer should be on and the mixing process should continue until a uniform and homogeneous dough is obtained.
۳. Leave the prepared tile adhesive paste for 5 minutes.
۴. Repeat the mixing operation for a short time and then pull the resulting glue on the surface with a slotted spatula and press the antique stone on it.
۵. For better adhesion, gently move the antique stone in place while squeezing. Seal the stoned surface after 24 hours.
Technical specifications of porcelain tile adhesive and large dimensions:
Specific weight: 0.05 ± ۱.۵ g / cm3
Physical state: powder
Color: gray and white
Density of ready dough: 0/05 ± ۱/۸۵
Chlorine ion: no
You can see other products of Dexter Building Chemical Industries here.